Weights and Measures Regulations

18 (1) With the exception of devices to which the Specifications Relating to Non-automatic Weighing Devices (1998) or the Specifications Relating to Timber Dimension Measuring Devices apply, the information required by these Regulations to be marked on a device shall be marked

• (a) on the device;

• (b) on a plate or plates permanently affixed to the device;

• (c) partly on the device and partly on a plate or plates that are permanently affixed to the device; or

• (d) in the case of a device not large enough to accommodate the required information in the manner referred to in paragraph (a), (b) or (c), on a notice attached to or displayed in close proximity to the device.

(2) If information is marked on a plate, a suitable area of not less than 12 mm by 25 mm shall be left blank on the plate for the examination mark referred to in section 30 and the plate shall be made of a durable material and shall be located and mounted so that it can be stamped with a steel die.

(3) The information required by these Regulations to be marked on the device shall be shown in numbers or letters that are

• (a) permanent;

• (b) clear;

• (c) of a height reasonably appropriate to the size of the device and, unless otherwise specified in these Regulations or in specifications established by the Minister, in numbers or letters of not less than 3 mm or 1/8 inch in height; and

• (d) located in such a place as to be readily legible by a person using the device under normal conditions of use.

(4) When numbers are used with letters or in place of letters on any marking on a device, the size and height of the numbers shall correspond to the size and height of the letters used or required to be used thereon by these Regulations.