Motor Vehicle Restraint Systems and Booster Seats Safety Regulations

Marginal note:Webbing

611 Any webbing that is designed to secure a restraint system for infants with special needs to a user-ready tether anchorage or to a lower universal anchorage system, or to restrain an infant with special needs within the restraint system, must

• (a) when tested in accordance with S5.1(b) of TSD 209, before being tested for resistance to abrasion as specified in S5.1(d) or S5.3(c) of TSD 209, for resistance to light as specified in S5.1(e) of TSD 209 or for resistance to micro-organisms as specified in S5.1(f) of TSD 209, have a breaking strength of

  • (i) at least 15 000 N, in the case of webbing designed to secure the restraint system to the user-ready tether anchorage or to the lower universal anchorage system, or

  • (ii) at least 11 000 N, in the case of webbing designed to restrain an infant with special needs within the restraint system;

• (b) when tested in accordance with S5.1(b) of TSD 209, after being tested for resistance to abrasion as specified in S5.1(d) or S5.3(c) of TSD 209, have a breaking strength of at least 75% of its initial breaking strength;

• (c) conform to the requirements of S4.2(e) and (f) of TSD 209 and subsections 209(3) to (6) of Schedule IV to the Motor Vehicle Safety Regulations; and

• (d) if contactable by the torso when the restraint system is tested in accordance with section 4 of Test Method 213.5, have a width of not less than 38 mm, measured as specified in S5.1(a) of TSD 209.