Government of Canada / Gouvernement du Canada
Symbol of the Government of Canada

Search

Motor Vehicle Tire Safety Regulations

Version of section 7 from 2013-11-08 to 2013-11-19:

The following provision is not in force.

Marginal note:Authorization by Minister

  •  (1) For the purposes of subsection 3(2) of the Act, on application by a company, the Minister may, in the form set out in Schedule 2, authorize the company to apply a national safety mark to a tire.

  • Marginal note:Application of the national safety mark

    (2) For the purposes of subsection 3(2) of the Act, when a company applies the national safety mark to a tire, the company must

    • (a) reproduce the symbol set out in Schedule II to the Act with the minimum height specified in Figure 2 of Schedule 1; and

    • (b) permanently mould the symbol into or onto one sidewall of the tire

      • (i) in one of the places shown in Figure 2 of Schedule 1, and

      • (ii) at a depth or height of not less than 0.5 mm and not more than 1 mm as measured from the immediate surrounding surface of the sidewall.


Date modified: