Heavy-duty Vehicle and Engine Greenhouse Gas Emission Regulations

Marginal note:National emissions mark

• 7 (1) The national emissions mark is the mark set out in the schedule.

• Marginal note:Dimensions

  (2) The national emissions mark must be at least 7 mm in height and 10 mm in width.

• Marginal note:Location

  (3) Subject to subsection 11(2), the national emissions mark must be displayed

  • (a) on or immediately beside the U.S. emission control information label or U.S. engine information label referred to in paragraph 53(d);

  • (b) on or immediately beside the compliance label applied in accordance with the Motor Vehicle Safety Regulations; or

  • (c) on or immediately beside the compliance label referred to in section 8, 9 or 9.1, as the case may be.

• Marginal note:Requirements

  (4) The national emissions mark must be displayed on a label that

  • (a) is permanently applied to the vehicle, engine or trailer;

  • (b) is resistant to or protected against any weather condition; and

  • (c) bears inscriptions that are legible and indelible and that are indented, embossed or in a colour that contrasts with the background of the label.

• Marginal note:Authorization number

  (5) Subject to subsection (6), a company that has been authorized to apply the national emissions mark must display the authorization number assigned by the Minister in figures that are at least 2 mm in height, immediately below or to the right of the national emissions mark.

• Marginal note:Exception

  (6) A company is not required to display its authorization number on a vehicle or trailer if

  • (a) the company is authorized by the Minister of Transport to apply the national safety mark in accordance with the Motor Vehicle Safety Act;

  • (b) the company applies both the national emissions mark and the national safety mark to the vehicle or the trailer; and

  • (c) the national emissions mark is displayed on the same label as the national safety mark.