Canadian Aviation Regulations

602.11 (1) In this section, critical surfaces means the wings, control surfaces, rotors, propellers, horizontal stabilizers, vertical stabilizers or any other stabilizing surfaces of an aircraft, as well as any other surfaces identified as critical surfaces in the aircraft flight manual.

(2) No person shall conduct or attempt to conduct a take-off in an aircraft that has frost, ice or snow adhering to any of its critical surfaces.

(3) Despite subsection (2), a person may conduct a take-off in an aircraft that has frost caused by cold-soaked fuel adhering to the underside or upper side, or both, of its wings if the take-off is conducted in accordance with the aircraft manufacturer’s instructions for take-off under those conditions.

(4) Where conditions are such that frost, ice or snow may reasonably be expected to adhere to the aircraft, no person shall conduct or attempt to conduct a take-off in an aircraft unless

• (a) for aircraft that are not operated under Subpart 5 of Part VII,

  • (i) the aircraft has been inspected immediately prior to take-off to determine whether any frost, ice or snow is adhering to any of its critical surfaces, or

  • (ii) the operator has established an aircraft inspection program in accordance with the Operating and Flight Rules Standards, and the dispatch and take-off of the aircraft are in accordance with that program; and

• (b) for aircraft that are operated under Subpart 5 of Part VII, the operator has established an aircraft inspection program in accordance with the Operating and Flight Rules Standards, and the dispatch and take-off of the aircraft are in accordance with that program.

(5) The inspection referred to in subparagraph (4)(a)(i) shall be performed by

• (a) the pilot-in-command;

• (b) a flight crew member of the aircraft who is designated by the pilot-in-command; or

• (c) a person, other than a person referred to in paragraph (a) or (b), who

  • (i) is designated by the operator of the aircraft, and

  • (ii) has successfully completed training relating to ground and airborne icing operations under Subpart 4 or relating to aircraft surface contamination under Part VII.

(6) Where, before commencing take-off, a crew member of an aircraft observes that there is frost, ice or snow adhering to the wings of the aircraft, the crew member shall immediately report that observation to the pilot-in-command, and the pilot-in-command or a flight crew member designated by the pilot-in-command shall inspect the wings of the aircraft before take-off.

(7) Before an aircraft is de-iced or anti-iced, the pilot-in-command of the aircraft shall ensure that the crew members and passengers are informed of the decision to do so.