Kamloops Airport Zoning Regulations (C.R.C., c. 88)

PART IAirport Reference Point

Being a point distant 500 feet measured southerly and at right angles to the centre line of Runway 08-26 from a point distant 3,139.2 feet, more or less, measured easterly along the centre line from the westerly intersection of the said centre line with the westerly boundary of Block 1 of Lot A, Kamloops Division, Yale District, Plan 3049, and which said intersection is distant southerly 1,095.25 feet, more or less, from the most westerly northwest corner of the said Block 1.

PART IIDescription of Outer Limits of Lands

Being two lines drawn parallel to and on opposite sides of and perpendicularly distant 7,500 feet from the centre line of Runway 08-26 and productions thereof, which centre line when produced westerly passes through an iron pipe in concrete on the west boundary of Block 1 of Lot A, Group 2, Kamloops Division, Yale District, Plan 3049, distant southerly 1,095.25 feet, more or less, from the most westerly northwest corner of the said Block 1, and which centre line when produced easterly passes through an iron pipe in concrete on the west boundary of Lot 5, Block 7, Kamloops Division, Yale District, Plan 2456, distant southerly 344.60 feet more or less, from the northwest corner of the said Lot 5 and two lines drawn at right angles to the said centre line from points distant 17,500 feet measured easterly and westerly along the said centre line and productions from the strip ends, which outer limits are shown on Department of Transport Plan No. V.226, dated January 15, 1969.

PART IIIDescription of Approach Surfaces

• 1 The approach surfaces abutting each end of the strip designated as 08-26 consisting of

  • (a) an inclined plane at right angles to each strip end and rising therefrom at a ratio of 1 foot measured vertically to 50 feet measured horizontally to an imaginary horizontal line drawn at right angles through the centre line of each strip, as produced, at a point 10,000 feet from each strip end measured horizontally and 200 feet above the elevation at each strip end measured vertically, the outer limits of the said horizontal line being 2,000 feet from the produced centre line; and

  • (b) an inclined plane from each inclined plane described in paragraph (a), at right angles thereto and rising therefrom at a ratio of 1 foot measured vertically to 40 feet measured horizontally to an imaginary horizontal line drawn at right angles through the centre line of each strip, as produced, at a point 17,500 feet from each strip end measured horizontally and 387.5 feet above the elevation at each strip end measured vertically, the outer limits of which imaginary inclined plane is 2,000 feet throughout from the produced centre line of the strip.

• 2 The approach surfaces abutting each end of the strip designated as 04-22 being an inclined plane at right angles to each strip end rising therefrom at a ratio of 1 foot measured vertically to 20 feet measured horizontally to an imaginary horizontal line drawn at right angles to each strip, at a point 3,000 feet from each strip end measured horizontally and 150 feet above the elevation at each strip end measured vertically, the outer limits of each imaginary horizontal line being 650 feet from each projected centre line.

• 3 Each of the approach surfaces described in sections 1 and 2 is shown on Department of Transport Plan No. V.226, dated January 15, 1969.

PART IVDescription of the Horizontal Surface

Being a surface consisting of a plane located 150 feet above the assigned elevation of the airport reference point, which surface is shown on Department of Transport Plan No. V.226, dated January 15, 1969.

PART VDescription of the Outer Surface

Being a surface abutting the lateral limits of the approach surfaces described in paragraph 1(b) of Part III of this schedule and the outer limits of the horizontal surface, being an imaginary plane located 2,000 feet above sea level or 30 feet above the surface of the ground at any given location, whichever is the higher at that location, which outer surface is shown on Department of Transport Plan No. V.226, dated January 15, 1969.

PART VIDescription of Each Strip

The strip associated with Runway 08-26 is 1,000 feet in width, 500 feet being on each side of the centre line of the runway, and 6,300 feet in length, and the strip associated with Runway 04-22 is 500 feet in width, 250 feet being on each side of the centre line of the runway, and 3,400 feet in length, which strips are shown on Department of Transport Plan No. V.226 dated January 15, 1969.

PART VIIDescription of Each Transitional Surface

Being a surface consisting of an inclined plane rising at a ratio of one (1) foot measured vertically to seven (7) feet measured horizontally at right angles to the centre line and centre line produced of each strip, and extending upward from the lateral limits of each strip and its approach surfaces to an intersection with the horizontal surface or another transitional surface of an adjoining strip, all as shown on Department of Transport Plan No. V.226, dated January 15, 1969.